Waterloo F1881 Bedienungsanleitung PDF herunterladen (Seite 5)

GAS SPRING INSTALLATION

Items Needed:

Gas Spring (Qty: 2)

M8-1.25 Hex Lock Nut (Qty: 4)

12mm Wrench

13mm Wrench

Process:

NOTE: Mount both Swivel Casters on the same side of the

unit as the handle.

• Attach Rigid Casters and Swivel Casters using (4) M8-

1.25 x 16mm Hex Head Screw, (4) M8 Washer, and (4)

M8-1.25 Hex Lock Nut in each caster.

• Wrench tighten.

• Discard screws in caster package (if supplied).

CASTER INSTALLATION

Items Needed:

Rigid Casters (Qty: 2)

Swivel Casters (Qty: 2)

M8-1.25 x 16mm Hex Head Screw (Qty: 16)

M8 Washer (Qty: 16)

M8-1.25 Hex Lock Nut (Qty: 16)

13mm Wrench

14mm Wrench

Process:

NOTE: Gas Spring must be installed with the cartridge

attached to lid (as shown).

• Insert threaded rod through hole in lid and secure with

locking nut.

• Insert bottom of Gas Spring in hole in divider rail and

secure with locking nut.

• Repeat for opposite side.

• Wrench tighten all fasteners on unit.

1.90

3.00

LOGO LABEL PLACEMENT

Process:

• Peel backing from logo label and position the label in

the upper right corner of the cart, using the dimensions

shown as a guide.

• Empty the drawer.

• Fully extend the drawer

Lever Style - Lift or lower (depending on the slide) the

release lever on both sides, (this allows the slides to ride

over the stops.) Pull out to remove.

OPERATION

Gas Spring

Nut

REMOVING DRAWERS

Release

Tab Style - Depress the release tabs on both sides,

(this allows the slides to ride over the stops.) Pull out to

remove.

1 2 3 4 5 6 7 8 9 10 ... 23 24

Kommentare zu diesen Handbüchern

Keine Kommentare

Waterloo F1881 Bedienungsanleitung Seite 5

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Werkzeug Waterloo F1881